Drift Pin Ratchet Tool The “Must Have” Job Site Tool for connecting Ductmate or TDC/F sections There’s a critical stage of the Ductmate connection that’s done on the job site in a less controlled environment than the confines of a Duct Fab shop: aligning and connecting the 2 mating gasketed duct sections. Though […]
Duro Dyne Magnetic Drift Pin Ratchet Tool Read More »
Duro Dyne Magnetic Cleater Tool for TDC/F Duro Dyne Magnetic Yellow Cleat Tool for TDC/F 6” Cleats speeds up process of connecting duct sections on the job site while also ensuring that the fab shop’s workmanship isn’t compromised with a few hammering miscues by someone in the field On a typical job, the rectangular duct
Are you cutting 20 ft Strut to 6 ft lengths? Many contractors take a 20’ length section of strut and cut it to just over 6’ long for some overhang on each side. Conklin stocks and sells 6’8” long strut as a labor saving option. Why 6’8”? Because 20’ divided by 3 = 6.7” The
Conklin is proud to be the only company in the Southeast region authorized as a licensed service provider of Sumner Lifts. Sumner 2118 Duct Lift (650-lb Capacity) Sumner 2100 Series Standard Features 12′, 18′ & 24′ heights (3.9 m, 5.6 m, & 7.2 m) 650 lb capacity (300 kg) Loading Bar – great
Sumner 2118 Duct Lift Read More »
Shoetap HETO—High Efficiency Take-Off Just about every commercial HVAC job has Shoetap HETO’s coming off of the rectangular duct into round pipe run outs. While a conical provides better air flow than a standard straight sided Airtite Takeoff, the HETO (High Efficiency Take-Off’s) surpasses even the conical for the best air movement. Designed with an
