Operation, Parts, and Maintenance Manual
4-FT by 16 Gauge Mild Steel Capacity Powered Roller. 3-inch Diameter rolls and 3-roll driven.
Item Code: TNSR48P
Two front rolls that sit almost on top of one another are the initial pinch rolls, the back roller is the bending roll. How tight the bending roll is adjusted to the two pinch rolls will determine the degree of the curve. This back bending roll comes standard with an Alignment Groove that runs across the Longitudinal of the roll. As the workpiece goes into groove, it squares up for proper forming serving the purpose like a square arm would serve to a 52″ Shear. Wiring Grooves are standard on the bottom of the two front rolls.
The smallest diameter pipe that a Power Roller can produce varies with the thickness of Galvanized but typically the rule of thumb (which also applies to Tennsmith’s SRP16) is that the minimum is 2x the roll diameter when used at capacity in gauge and in width. The roll diameter is 3″ when used at capacity (16ga) and at full width (48″).
On 16ga x 48″ long, the smallest diameter produced is 6″ because the roll diameter is 3″. On lighter gauge and shorter pieces there’s an varying ability of rolling to a smaller diameter.
Price: $9,350.00 USD (220V/3PH/60Hz)
(Pricing effective August 2024)
